Newsletter
Subscribe to our newsletter
Cleaning and maintenance

WASHING IN THE MACHINE (CHEMICAL WASH IS NOT ALLOWED!!!)

Printouts should be washed in lukewarm water using generally available detergents for soft materials. Spin at the lowest speed, but no more than 400 rpm. 

Attention:

- CHEMICAL WASH is not allowed!!!
- it is forbidden to use detergents containing CHLORINE!!!
- it is forbidden to use chemical products based on gasoline or solvents!!!
- it is not allowed to use detergents containing acids!!!
- heavily soiled prints, i.e. in a situation where they were used, especially outside for a long period without maintenance, are no longer - suitable for cleaning (they can not be cleaned),
- ironing using iron or ironing machine at 150-170 degrees C.
- ironing from the left side is recommended,

STEAM WASHING

To increase the effect it is recommended to perform a steam wash when the printout is put on the system. In the device there should be mineral or distilled water, avoid hard water. Hold the device close to the printout, being careful not to touch it. Check that no water drips from the appliance, as it may leave traces.


EMERGENCY CLEANING

CLEANING WITH WATER

The fabric must be removed from the system for cleaning. Place a dry, clean cloth under graphic that will absorb excess water. Then use a damp cloth to soak the cleaning place (it is recommended to use distilled water, avoid hard water) and gently rub to remove the dirt. Finally, dry the cleaned surface by applying a dry cloth or paper towel. The operation should be performed until the fabric is almost completely dry.

CLEANING WITH WATER AND FLUID DETERGENT

It should be noted if the liquid does not react with the print. For this purpose it is necessary to dampen the printout with the liquid in an unseen place and wait for a while. To try to remove the stain, you must remove the fabric from the system. Under graphics place a dry, clean cloth that will absorb excess water. Then use a damp cloth to soak the cleaning place (it is recommended to use distilled water, avoid hard water) and gently rub to remove the dirt. Finally, dry the cleaned surface by applying a dry cloth or paper towel. The operation should be performed until the fabric is almost completely dry.

up
Shop is in view mode
View full version of the site
Sklep internetowy od home.pl